查询
1 词典释义:
shear strength
时间: 2025-09-28 07:58:31

n.切变强度;剪切强度

双语例句
  • The shear strength is equal to the cohesion of substance.

    剪切强度等于物质的内聚力。

  • It is shown that the bumps can supply sufficient shear strength for use.

    由实验结果可知钎料凸台可以提供足够的剪切强度。

  • Moreover, the statistical methods of shear strength of soils are summarized.

    对土的抗剪强度指标的统计方法进行了总结。

  • For unsaturate sands, oil pollution has no prominent influence on shear strength.

    石油污染对非饱和砂土抗剪强度影响不显著。

  • Furthermore, the shear strength formula of concrete hollow brick masonry is proposed.

    提出了混凝土空心砖砌体的抗剪强度计算公式。

  • In this article we do not give any specific shear strength, just some relative values.

    在这篇文章我们不给予任何具体的抗剪强度,只是一些相对价值。

  • The corrosion resistance of epoxy adhesive was assessed by its tensile shear strength.

    环氧胶粘剂的耐蚀性能是通过测定其拉伸剪切强度来评定的。

  • The shear strength of BGA joint with eutectic solder is higher than that of tin-lead alloy itself.

    共晶钎料BGA球焊点的抗剪强度比锡铅合金钎料自身的抗剪强度大。

  • The undrained cyclic shear strength of the silt is about 50% of the static undrained shear strength.

    该淤泥在波浪作用下的固结不排水剪切动强度约为静固结不排水强度的50%。

  • This paper deals with the calculation of the shear strength of reinforced lightweight concrete beams.

    本文就钢筋轻骨料混凝土梁的抗剪强度计算问题进行了论述。

  • Therefore, considering influement of unit weight, shear strength as anti-erosion index is reasonable.

    考虑到容重的影响,把抗剪强度作为抗蚀力指标还是较为合理的。

  • This paper firstly presents relationship between stress-strain, shear strength and size sample of gangue.

    本文首先讨论煤矸石的应力-应变、抗剪强度二者与试样尺寸的关系;

  • At last, the effect of soil gradation on the shear strength of unsaturated soils is analyzed qualitatively.

    最后分析了土颗粒半径差异、土体平均粒径大小对非饱和土强度的影响。

  • The effects of secondary torsion on shear strength of biaxial flexural reinforced concrete beams are analyzed.

    探讨了次生扭矩对钢筋混凝土双向受弯梁抗剪承载力的影响。

  • Results the transverse strength and shear strength were increased with the increase of the carbon fiber content.

    结果随着碳纤维含量的增加,根管桩的弯曲强度和剪切强度均逐渐增加。

  • Furthermore, the shear strength formula of multifunction multifunction concrete hollow brick masonry is proposed.

    提出了多功能混凝土空心砌块砌体的抗剪强度计算公式。

  • Through shear test, effects of slope soil water content on soil shear strength of different vegetation were studied.

    本文通过直剪试验,研究边坡土壤含水率对不同植被类型土壤抗剪强度的影响。

  • Bonding temperature, bonding time and interlayer thickness have an obvious effect on the shear strength of the joints.

    连接温度、连接时间和中间层厚度对接头抗剪强度具有较明显的影响。

  • The results showed that the shear strength of fractal joints decreases nonlinearly as the filling percentage increased.

    结果表明,随着充填度的增大,分形节理抗剪强度总体上呈非线性减小。

  • Stability problem, accelerate to increase shear strength of the foundation soil, raise the bearing capacity and stability.

    稳定问题,加速地基土的抗剪强度的增长,从而提高地基的承载力和稳定性。

  • And the masonry shear strength of (concrete) hollow brick is higher than that of clay solid brick and concrete hollow block.

    混凝土空心砖砌体的抗剪强度要高于粘土实心砖、混凝土空心砌块砌体的抗剪强度。

  • The shear strength of dry sand has been studied, the result shows the interlocking strength existing interdry sands compacted.

    对干砂的抗剪强度进行了研究,认为型砂存在咬合强度。

  • Soaking leads to a significant increase in compression deformation and a significant reduction in shear strength and cohesion.

    压实粘土浸水饱和后,压缩变形显著增加,抗剪强度和粘聚力则显著降低。

  • Result: Isogradient HA-coated implants had a greater average interface shear strength than the uncoated ones at each time span.

    结果:术后每一时间段涂层植入体界面抗剪强度均显著高于非涂层者。

  • The shear strength between soil and structure interfaces in high stress is one of key research in shaft lining fracture theory.

    高应力下土与结构接触面抗剪强度研究是当前井壁破裂理论研究的关键之一。

  • The formula of reduced shear strength coefficient of RC beams with inclined cracks is put forward to according to the test data.

    根据试验数据提出了存在斜裂缝钢筋混凝土梁的抗剪强度折减系数的计算公式。

  • Three typical manifestations of wafer bonding strength were introduced as tensile strength, shear strength and adhesive strength.

    介绍了三种典型的圆片键合强度表现形式:抗拉强度、剪切强度和粘接强度。

  • Influences of the metallizing technologic conditions, Ni plating and subsequent annealing on the joint shear strength were investigated.

    考察了金属化工艺、镀镍及镀后热处理对接头剪切强度和钎焊效果的影响。

  • I have a chance to use the equipment of triaxial test which import from England and to carry on research shear strength of asphalt mixture.

    本文有机会借助英国进口的三轴剪切试验设备,对沥青混合料的抗剪性能采用三轴剪切试验进行深入研究。

  • The parameters of shear strength of slide zone soil are indispensable factors for stability evaluation and countermeasure design to landslides.

    滑带土抗剪强度参数的正确选取,是滑坡稳定性评价和抗滑工程设计中的关键问题。