查询
1 词典释义:
friction coefficient
时间: 2025-10-06 22:26:48
英 [ˈfrɪkʃ(ə)n ˌkəʊɪˈfɪʃ(ə)nt]
美 [ˈfrɪkʃ(ə)n ˌkoʊəˈfɪʃənt]

摩擦系数

双语例句
  • That should allow you to also calculate the friction coefficient.

    你们同样可以,计算摩擦系数。

  • The friction coefficient decreases with the increase of load.

    随载荷的增大摩擦系数减小;

  • This is a way that you can measure the static friction coefficient.

    这是测量静摩擦,系数的一种方法。

  • I'll give you the Angle and I want you to calculate that friction coefficient.

    我会读出角度,你们帮我计算摩擦系数。

  • I told you that the friction coefficient is independent of the mass of the object.

    我讲过,摩擦系数,与物体质量无关。

  • Friction coefficient increased with abrasive size and concentration increased.

    当磨料的添加量和粒度增加时摩擦系数增大。

  • The humidity could change in the room and that could change the friction coefficient.

    室内的湿度会随时变化,这对摩擦系数影响很大。

  • Advantages: good toughness, low friction coefficient of the ruby head, long life.

    优点:有较好的韧性, 宝石头部摩擦系数低,具有超长的使用寿命。

  • Low friction coefficient guides to ensure that the barrel weight fully to the mattress.

    低磨擦系数导轨,保证滚桶重量完全作用于床垫上。

  • Typically, the staticfriction coefficient is higher than the kinetic friction coefficient.

    静摩擦系数典型地高于动摩擦系数。

  • If the roll core is made of special materials, smaller friction coefficient of tile can be used.

    客户的卷芯如果是特殊材料制造的,可采用摩擦系数较小的瓦片材料。

  • And more significantly, it has very low friction coefficient and nice self-lubricating properties.

    更有意义的是它具有超低的摩擦系数和优良的自润滑性能。

  • With special raw material (raw rubber bearing) and small friction coefficient; electricity -saving.

    含特殊原料原橡胶轴承,摩擦系数小,更省电。

  • The humidity results in low friction coefficient, but the braking presure will decrease the effect.

    湿态环境下平均动摩擦系数降低,但随着压力的增大,这种影响减小。

  • It is the high surface energy that contributed to larger friction coefficient of polyurethane threads.

    高表面能引起的粘着为聚氨酯摩擦系数较高的主要原因。

  • The low density graphite gets higher friction coefficient and bulk worn loss than the high density graphite.

    低密度石墨的摩擦系数和体积磨损量比高密度石墨材料高。

  • So you should be able to calculate what the friction coefficient is using the equation tangent alpha equals mu s.

    你们则需要学会,计算摩擦系数,使用μ静=tanα这个公式。

  • The frictional force remains constant, dependent on the friction, the kinetic friction coefficient, is always the same...

    摩擦力不守恒,它取决于摩擦力,动能摩擦系数,一直是相同的。

  • In the default model the friction coefficient is defined as afunction of the equivalent slip rate and contact pressure.

    在默认模型里,定义摩擦系数为等效滑移率和接触压力的函数。

  • The variation of local friction coefficient is similar to velocity and local minimum value occurred in reverse flow area.

    摩擦阻力的变化趋势与速度类似,在产生逆向流处出现局部极小值。

  • That should allow you to calculate the static friction coefficient and you'll get a chance to do that in your third assignment.

    这样一来,请计算静摩擦系数,它将作为你们第三次作业的,一部分。

  • The experimental results indicate that this material possess low friction coefficient and excellent antifriction property.

    试验结果表明:此各材料具有较低的摩擦系数和良好的减摩耐磨性能;

  • It is found that the friction coefficient increases with the increase of sliding velocity, and there is critical velocity.

    试验发现,摩擦系数随滑动速度的增加而增加,存在临界滑动速度。

  • When selecting brake shoe, the dynamic friction coefficient must fulfill the request of both brake capability and stability.

    选择鼓式制动器摩擦片时,动摩擦系数的选择既要满足制动性能,同时也要满足稳定性。

  • However, the friction coefficient between Ni and APS increased with sliding velocity increasing and reduced with load increasing.

    而镍与APS间的摩擦系数随滑动速度的增大而增大,随载荷的增大而减小。

  • Hardness and friction coefficient of the three composites were determined to investigate the influence of particle type and content.

    研究了颗粒性质和含量对复合材料硬度、摩擦系数和耐磨性能的影响。

  • If indeed the friction coefficient is independent of surface area, then when I tilt them they should start to slide roughly at the same Angle.

    若摩擦系数真的,与接触面积没有关系,那么两者下滑时的角度,应该基本相当。

  • This brush holder of technology and structure has obsolete technology, lack of support structure is complex and the friction coefficient.

    这种刷握的技术和结构己陈旧过时,技术中的不足是支架结构复杂摩擦系数大。

  • The effects of metal base content and NiCr alloy addition on hardness, friction coefficient and wear rate of the composites were studied.

    研究了金属基体及其中镍铬合金的含量对复合材料的硬度、摩擦系数和磨损率的影响。