And the asymptotic stress ratio is a little larger for the specimens with vertical bedding plane than that with horizontal one.

相对于沉积面水平的试样而言，沉积面铅直的渐近状态应力比稍大；

The permeability coefficient on the direction vertical to the bedding plane is larger than that on the direction parallel to the bedding plane.

垂直于层理方向上的渗透系数大于平行于层理方向上的渗透系数。

On this basis, from the enterprise microseism bedding plane, it develops and gives the synthetically study frame about resource, ability, surround environment and compete superiority.

在此基础上，从企业的微观层面，推演给出资源、能力、外部环境、竞争优势整合研究框架。

In addition, the layer separation exists in the end of span of overburden if the subsidence happens in whole overburden, which is resulted from the shear failure of the bedding plane.

另外，当覆岩发生整体下沉时离层主要存在于跨度两端，离层由层理剪切破坏引起。

A case history of the application of the P-wave reflection method in that area to investigate the bedding plane of bedrock, karst cave, fault and the distribution of the dissolution belt is given.

文中给出了该区P波反射法探测基岩界面、溶洞、断层和溶蚀带分布的应用实例。

The mathematical model with finite solution for bedding plane air-leakage is established, in which the air leakage intensity is regarded as attenuating follows proximately negative exponential law.

建立了层面漏风的定解数学模型，将地表漏风强度近似看作按负指数规律衰减。

The breakage of bedding slope can be calculated as plane slippage, and the coulomb formula is fit for it.

顺层边坡的破坏可以按照平面滑移面计算确定发生变形的判据，库仑方程是这种破坏适宜的破坏判据。

Through the engineering practice, the bedding failure mechanisms of bedded rock side-slope could be divided into three types: plane rotatory sliding, disintegration sliding and gradual destruction.

通过工程实践，将层状岩体边坡顺层破坏机理归纳为三方面的问题，即：平面旋转滑动、解体滑动和渐进破坏。

In order to analyze weak plane grouting effect of consequent bedding rock slope, it is simulated by numerical analysis model which is based on Lagrangian difference method.

为了分析顺层岩质边坡弱面注浆效应，采用了基于拉格朗日差分法的数值分析模型对其进行模拟。

The utility model solves the problem of the existing die cutter needing the bedding under the stamping-out object to keep the cutting plane of the cutter parallel with the stamping-out plane.

本实用新型解决了现有模切机需在被冲压物下面进行铺垫才能使刀具切割平面与被冲压面平行的问题。