I wish he'd been soldered in lead.

我愿把他用铅焊住。

Soldered or tinned annealed wire.

焊锡或镀锡的导线。

I then soldered up the top and bottom of the boiler.

当时我焊接起来的顶部和底部锅炉。

I superglued the switch and the soldered the contacts.

我用强力胶水粘上了开关，并焊接好了触点。

The third step, the cable soldered to the solder hole.

第三步，把电缆焊接到焊接孔上。

Measurement point is soldered by high temperature tin.

量测点以高温锡丝焊接。

It consists of about 10 parts which I soldered in 2 steps.

它约十个部分，我焊接在2个步骤。

A broken friendship may be soldered but will never be sound.

破裂的友谊可以重归于好，但绝不会亲密无间。

The third step, the cable soldered to the pin hole soldering.

第三步，把电缆焊接到针焊接孔上。

The battery was not soldered to anything and was easy to replace.

l电池并无焊接，可以轻松更换。

I then stuck one of my NiCu rods into the hole and soldered it into place.

当时我坚持我的一个新生儿加护中心棒到孔和焊接成的地方。

Once you have soldered the first batch of LEDs, it's time to add even more.

一旦你有焊接led的第一批，是时候增加更多。

I endeavoured to uncap the casement, but the hook was soldered into the staple.

我试着去打开那窗子，但窗钩给焊在钩环里了。

The international standard specifies a soldered pin connector for circuit boards.

国际标准为电路板选定了焊接针连接器。

The capsule element system consists of two capsule element halves soldered together.

膜盒系统包括两个焊接在一起的膜盒半元件。

I then placed the spacer where I wanted it to be soldered and applied heat to the joint.

然后我把间隔的地方我想它是焊接和应用热向联合。

There are sixteen (16) relays inside the box that are soldered in place to a perf board.

有16(16)继电器方框内是在焊接的地方，一个性能董事会。

The was soldered into the staple: a circumstance observed by me when awake, but forgotten.

我醒的时候看见窗扣是和台子焊在一起的，但是忘记了。

Air distribution piping systems almost invariably use soft copper tubing with soldered fittings.

压缩空气的分配管道系统无例外地都是用焊接管件的铜管。

Careful inspection showed that the statue's head had been cast separately and soldered in place.

仔细检查发现雕像的头部是铸好后再焊接上去的。

If we are unable to remove the oxide coat, even it is reluctantly soldered, the bonding strength is very weak.

如果我们未能将氧化层除去，即使勉强沾上焊锡，其结合力量也是非常弱的。

In this photo, a worker heats a computer board on a steel surface to remove the computer chips soldered into it.

图中的这位工人在一块钢板表面加热一块电脑电路板以取下焊接在上面的芯片原件。

But nine days later a single electrical splice overheated because it had been badly soldered, and disaster struck.

但9天之后一个简单的电气连接因为焊接不良过热造成伤害。

A copper foil solution is used to bond the glass pieces together, and then the pieces are soldered together firmly.

铜箔解决方案可使玻璃碎片结合在一起，然后一起焊接牢固。

Replacement of diodes that are soldered to the heat sink is permitted provided that a controlled heat source is used.

如果使用了可以控制的热源，可以更换焊到散热片散热板上的二极管。

I resolved to silence it, if possible; I endeavoured to unhasp the casement, but the hook was soldered into the staple.

我决定把这声音止住，如果可能的话。我试着去打开那窗子，但窗钩给焊在钩环里了。

The capacitors shall not be effected by any radiated heat from the soldered PC board or other components after soldering.

焊接后的电容器不应受到任何已焊接p C板或其他元器件热辐射的影响。

The Nokia 5800's earpiece isn't soldered onto the contacts on the circuit board, rather it's pressed into the circuit board.

诺基亚5800的耳机是不是焊接在接触的电路板，而不是它的压入的电路板。

Solder end valves are designed to be soft soldered into lines without disassembly, using a low temperature solder (400of) (204oc).

焊接端口阀门适用于不需要拆卸的软焊接管线，采用低温焊料(204oc)。