Absolute AGC is important for both control of gauge in same. plate and control of tolerance hand of aim thickness.

绝对值A GC 在控制同板差的同时，对目标厚度及其公差带的控制也至关重要；

Based on the cause of gauge oversizing of plate head, the traditional head gauge compensation methods were analyzed.

基于中厚板轧制过程中头部厚度超差原因，分析了传统的头部补偿方法的不足之处。

Packing gauge: a measuring instrument which is used to determine the space between plate, or blanket, and the cylinder bearers and thus, the amount of packing needed.

衬垫厚度计：测量仪器。用来测量印版，胶布和圆筒肩铁间的空位，因此而决定衬垫所需的厚度。

Bulk freight wagons with pressure discharge; pressure gauge with plate spring, radial bottom flange connection.

带压力卸料装置的散装料运货车。带板簧的压力计。径向。

The hydraulic automatic gauge control( HAGC) isa key technology in plate rolling.

液压自动厚度控制（ HAGC）是板材轧制的关键技术。

The article describes the automatic gauge control, cause of thickness deviation, setup of control models and thickness control and adjustment of the single stand cold plate mills.

介绍单机架冷轧机厚度控制系统、产生厚差的原因、控制模型的建立及厚度的控制和调节。

It is indicated that the precise flat Plate, hollow column and clock gauge should be selected properly to satisfy actual requirements for measuring accuracy of oil well pump liners.

指出在实际生产中应根据需要选择合适精度的精密平板、空心立柱和千分表来装配，以满足抽油泵衬套测量精度要求。

The influence of data treatment method for measured force and gap and plate crown on gauge calculation is also analyzed.

同时分析了实时轧制力和辊缝数据的处理方法对厚度计算的影响。

The gauge control system especial AGC system can deteriorate open loop control of plate shape especially when the mill rigidity is small, making edge wave of rolling plate.

厚度控制系统特别是AGC系统对中厚板板形的开环控制有一定影响，特别是刚度偏小的轧机在轧制宽薄中厚板时容易出现边浪。

For this reason, we develop a model which can calculate thickness for plate rolling, and an X-ray thickness gauge monitor and several compensation algorithms are used to compensate model error.

为此建立了钢板的高精度厚度计式模型，采用X射线测厚仪检测参数和各种补偿算法对计算模型进行修正。

It is indicated that the precise flat Plate, hollow column and clock gauge should be selected properly to satisfy actual requirements for measuring accuracy of oil well pump...

指出在实际生产中应根据需要选择合适精度的精密平板、空心立柱和千分表来装配，以满足抽油泵衬套测量精度要求。