查询
1 词典释义:
resistive load
时间: 2025-11-16 14:53:17
英 [rɪˈzɪstɪv ləʊd]
美 [rəˈzɪstɪv loʊd]

电阻性负载;阻性负载;阻力负荷

双语例句
  • Test by minimum Vin and constant resistive load.

    测试的最低输入电压和恒定电阻负载。

  • Resistive load, power factor: 1, special alloy resistance.

    阻性负载,功率因数为1 。采用特制合金电阻。

  • General pulsers can obtain sharp risetime only when it is used for a resistive load.

    通常的脉冲发生器只是在电阻性负载时才能得到陡的上升沿。

  • On Day 8, it is time to gradually build up the non-resistive load on the Magravs PowerUnit.

    第8天,这段时间逐渐在能量装置上建立非阻性负载。

  • This paper analyzes the harmonic component of the bridge type current limiter with resistive load.

    以阻性负载为例分析了桥式限流器的谐波问题。

  • A resistive load placed at the end of a cable to prevent data signals from reflecting back into the data path.

    终结器就是置于电缆终端的一个电阻负荷,用来防止数据信号又反射回到线路中去。

  • Buffer amplifier An amplifier, usually in a gain of 1 or 2, used to drive a heavy capacitive or resistive load.

    缓冲器放大器一种放大器,通常可以放大1到2倍,用于驱动大容量或大阻抗负载。

  • Feasibility of the proposed scheme is confirmed with experimental results under resistive load and rectifier load.

    阻性负载及整流负载情况下的实验结果证实了该控制方案的可行性。

  • The simple experimental circuit contact material is designed using time relays with digital display, contactors, switchgear and resistive load.

    利用数字显示时间继电器、交流接触器、断路器以及电阻性负载设计了一个简易的触头材料实验电路。

  • Because the bank adopts late-model components, high power density, it has not red-hot phenomena. It is pure resistive load and three-phase current balance.

    本机采用新型功耗组件,功率密度高,无红热现象,为纯阻性负载,三相电流平衡。

  • The model uses the effective impedance of the microstrip line as the value of matched resistive load and assign it into the RL mesh region in a proper proportion.

    该模型将微带线的有效阻抗作为匹配负载电阻,然后按适当的比例分布到端接面的网格中。

  • The experimental model designed was used to measure arc voltage and current waveforms of alloyed contact in resistive load circuit and inductive load circuit on the condition of room temperature;

    应用自行设计的实验模型,在室温条件下,并在电阻性电路和电感性电路中,测量了金合金触点的电弧电压和电弧电流波形;

  • Practical application demonstrates that the circuit has good performance with resistive or inductive load.

    实际结果表明,电路对电阻性或电感性负载均具有较好的控制性能。

  • Pulse width modulation is used to reduce the total power delivered to a load without resulting in loss which normally occurs when a power source is limited by a resistive element.

    脉宽调制技术是用来降低总功率交付给了负荷,没有造成损失,这是通常发生时,电源是有限的,由电阻芫件。

近义词
电阻负载