Shear modulus and damping ratio change very little.

动剪切模量与阻尼比的变化比较小。

Contrast quivalent dynamic shear modulus and damping ratio of different soil types.

最后分析了同类土静、动强度参数之间的比例关系；

This paper presents a method to identify transverse shear modulus for composite materials.

本文提出一种测试复合材料横向剪切弹性模量的参数识别方法。

The values of the dynamic shear modulus and the damping factor are close to those of sandy soil.

动剪切模量和阻尼特性接近于砂性土。影响阻尼特性最明显的因素是剪应变和周压力。

The spring element stiffness is related to pre yield shear modulus of MR fluid and accumulator stiffness.

该弹簧单元与磁流变液屈服前区的初始剪切模量和蓄能器的刚度等有关。

The straightforward procedures to achieve shear modulus of colloform and maximum shear stress are specified.

提出了求解胶体剪切模量和最大剪应力的简单方法。

A model is proposed for predicting the effective longitudinal shear modulus of fiber reinforced composite materials.

本文给出一个计算单向纤维增强复合材料纵向剪切模量的模型。

Elastic shear strain in shear band was dependent on shear elastic modulus, damage variable and residual shear modulus.

考虑刚度劣化后，剪切带的弹性应变由弹性剪切模量、损伤变量及残余剪切模量确定。

This article describes the improved shear modulus can increase the profiled rubber bearing, and puts forward a new bearing.

本文介绍了改进后能提高抗剪弹性模量的异型板式橡胶支座，并在此基础上提出新型支座。

The shear stress sharply rises at the ends of the piezoelectric as the shear modulus increasing or the thickness decreasing.

随着粘贴层的切变模量的增加或其厚度的减小，切应力在靠近压电致动器端部区域迅速增大。

However, the interface strength decreases after size scaling while the initial shear modulus increases, which cannot be ignored.

而粒径缩尺后的接触面强度会降低，同时初始剪切模量则有所增长，其影响不能忽略。

The axial shear modulus has been derived in closed form by using the conformal mapping approach integrated with the Laurent expansion.

利用解析函数的保角变换与罗朗级数展开，获得了轴向剪切模量的封闭公式。

The shear stress rises sharply at the ends of the piezoelectric actuator with the shear modulus increasing or the thickness decreasing.

随着粘贴层的剪切模量的增加或其厚度的减小，剪切力在靠近压电致动器端部区域迅速增大。

At the same time, the effect of stress path circumgyration on shear modulus decreases gradually along with the increase of shear strain.

同时由应力路径旋转对模量的影响也随着剪切应变的增加而逐渐衰减。

Results show that, conventional point dipole model has overrated the magnetic-induced shear modulus of the magnetorheological elastomers.

计算结果表明，传统的点偶极子模型高估了磁流变弹性体的磁致剪切模量；

Where the flux line lattice moves perpendicular to the filament direction, the data show that the shear modulus, C66, governs the flux pin.

当磁通线阵运动垂直于细丝方向时，其数据表明剪切模量C _(66)主要起针扎作用。

Based on the magnetic interaction energy, a model was proposed to compute the magnetic-induced shear modulus of magnetorheological elastomers.

从颗粒间的磁相互作用能出发，计算了磁流变弹性体的磁致剪切模量。

Numerical results demonstrate the variations of the effective antiplane shear modulus of such heterogeneous materials with microstructure parameters.

数值结果给出了该类非均匀材料有效反平面剪切模量随微结构参数变化的规律。

Assuming that shear modulus of the soil foundation is linear along depth, the mean and the variance of the maximal displacement response are obtained.

假定土层的剪切模量随深度线性变化，得到土层的最大位移反应的均值和方差。

The test results show that the shear modulus of the elastomer will not decrease with enhancing compression which agreed with well with the simulation.

试验结果发现，橡胶材料的剪切模量并没有随压力的升高而减小，该现象与计算结果吻合较好。

Moment magnitude is transformed from seismic moment, so the estimation inaccuracy of stress drop and shear modulus will affect moment magnitude scaling.

矩震级标度是从地震矩换算过来的，换算关系中地震应力降与剪切模量估算的不准确会对矩震级标度产生影响。

This dissertation mainly studies the relations between shear wave velocity, dynamic shear modulus, damping ratio and other physical indicators of soils.

本文主要研究土层剪切波速、土动剪切模量和阻尼比以及它们和土的其它物理指标的关系。

The prediction result of the in plane shear modulus of a typical stitching foam-core sandwich composite was found good agree with the experimental results.

预测典型缝纫泡沫芯材的面内剪切模量，进行夹层结构的面内剪切试验，试验结果与预估结果吻合较好。

The proposed model takes into account the shear modulus, the damping ratio, pore water pressure and permanent deformations of pavement foundation materials.

该模型可以全面考虑路基材料的剪切模量、阻尼比、孔隙水压力以及永久变形。

Some problems in the measurement of performance of composite material structures, such as the identification of the transverse shear modulus, can be solved.

该方法能够解决正交各向异性复合材料剪切模量的识别等当前复合材料结构性能测试中存在的一些难点问题。

The results show that the bulk modulus, shear modulus and elastic modulus decrease remarkably with the increasing degree of wavy and the missing of cell wall.

胞壁弯曲和胞壁缺省对多胞固体产生极大影响，多胞材料的体积模量、剪切模量和弹性模量随胞壁弯曲程度、胞壁缺省的增加显著下降。

A new formula for evaluating the maximum dynamic shear modulus of the sand under the anisotropic consolidation is presented by using the resonant column method.

采用共振柱试验方法，提出了一个非均等固结下砂土最大动剪切模量新的增长公式。

As the name suggests, this kind of nature and so on material in mechanics direction elasticity coefficient and shear modulus changes along with the length change.

顾名思义，这类材料在力学方向上的弹性模量及切变模量等性质随长度的变化而变化。

The results showed that increasing the thickness and elastic modulus of CFRP, using moderate thickness and shear modulus of adhesive led to good strengthening effect.

结果表明：提高CFRP的弹性模量、厚度，采用适当的胶层剪切模量、厚度，对提高加固效果显著。