Ceramic substrade, High efficiency and low thermal resistance.

高光效、低热阻陶瓷基板。

The char, the decomposition product of PPPBP has outstanding thermal resistance.

PPPBP分解产生的残炭有突出的耐热性能。

The study of oxidation resistance coatings and thermal resistance coatings was overviewed.

综述了目前国内外抗高温氧化涂层和热障涂层的研究现状。

Before set up this thermal resistance virtual prototypes, we need built its mathematic model.

在建立机床导轨的热阻虚拟样机的时候，首先要建立它的数学模型。

Theoretical model of heat pipe thermal module was built using thermal resistance network method.

采用热阻网络法，得出热管散热模组的数学模型。

The thermal resistance of industrial, platinum thermal resistance and thermal resistance of two kinds of.

工业用热电阻，铂热电阻和铜热电阻两大类。

The difference of thermal resistance of fabric with different surface structure is studied in this paper.

研究正反面结构有明显差异的立绒织物在传热性能上的方向性。

The experimental results for devices with higher thermal resistance are contrary to the above conclusions.

热阻较大的器件，实验的结果与以上结论相反。

In this paper the operating principles of the platinum thermal resistance temperature sensor is analyzed,.

分析了金属热电阻温度传感器的工作原理。

The effect of the thermal resistance at two interfaces on heat dissipation capability of the SWS is analyzed.

分析了两个接触处的界面热阻率对慢波结构散热性能的不同影响。

The effects of interface thermal resistance on the evolution of temperature and solidification are discussed.

分析不同界面热阻对温度分布以及凝固过程的影响。

Excellent protection for all the system components to oxidation due to its fluidity and high thermal resistance.

基于它的流动性和高耐温性，给所有系统部件以卓越的抗氧化保护。

The experiment data of measuring the clothing thermal resistance by the apparatus were analyzed when human body in dress.

分析了用该仪器在人体着装条件下测量服装热阻的实验数据。

The steady state thermal resistance has important influence on the life test by researching the discrete semiconductor devices.

在进行相关分立器件分析时发现，稳态热阻对功率器件寿命试验结果影响较大。

This paper suggests that the change of the steady state thermal resistance should become one of the criterions of the life test.

通过相关案例分析，提出稳态热阻的变化量应作为功率器件寿命试验合格判据之一的建议。

A new method of pulse measurement is presented for reference thermal resistance test based on the electrical measurement method.

提出了一种新的基于电学测试的参考热阻测试方法——脉冲测量法。

There is no uniform calculation method for buried directly pipeline because of more complicated circumstances of thermal resistance.

对于直埋地下的管道，由于环境热阻比较复杂，其传热计算方法尚不统一。

Thermal resistance is characterized by having large measurement range of temperature, good stability and excellent anti-oxidation etc.

热电阻具有测温范围大、稳定性好和耐氧化等特点，在温度测量中占有重要的地位。

At last, influences of the suit thermal resistance and impermeability index to body hot load ware analyzed with the modal built above.

最后利用所建模型分析服装热阻及透湿指数对人体热负荷的影响。

The parameter of the block is gained when its thermal resistance value is maximum by the guarded hot box and the numerical simulation.

利用防护热箱法和数值模拟方法得到了砌块热绝缘系数最大时的砌块的结构。

In Australia we use the metric system of measurement and the rating of insulation is known as the R-value which means thermal resistance.

在澳大利亚，我们使用公制计量方法并且绝缘等级即被作为代表耐热能力的热阻值。

Thermal resistance in the formation around a well is the basic datum and is concerned to the temperature distribution of oil in wellbore.

地层热阻是稠油和高凝油进行热力开采时的重要基础数据，它关系到采出原油在井筒中的温度分布。

Two-branch platinum thermal resistance mainly used in occasion of the same place temperature was measured and adjusted by two display instrument.

双支铂热电阻主要用于需要由两个显示仪表同时测量和调节同一地点温度的场合。

The thermal resistance of the heating part (temperature sensor) is made of metal wire even double wound on the insulating material on the skeleton.

热电阻的受热部分(感温元件)是用金属丝均匀地双绕在绝缘材料制成的骨架上。

Thermal resistance is when the temperature changes its resistance along with the characteristic changes of temperature measurement using the material.

热电阻是利用物质在温度变化时自身电阻也随着发生变化的特性来测量温度的。

This paper introduced a thermal resistance model of semiconductor laser diode, and analyzed wavelength control technology of laser diode in dense WDM system.

本文利用半导体激光器的热阻模型，研究分析了密集波分复用系统中光源的波长控制技术。

The definition of ballast rated maximum temperature was analyzed, a thermal resistance model for measurement of ballast rated maximum temperature was set up.

分析了电子镇流器额定最高温度的定义，建立了电子镇流器额定最高温度测量的热阻模型。

Moreover, with simulation circuit method the thermal resistance of block is formulated, which can accurately state the thermal characteristics of building blocks.

进而采用电算法求出砌块的热阻，使得计算结果能精确地反映墙体砌块的热工性能。