The measures to prevent reheater tube failure are presented.

提出了预防屏式再热器爆管的有效措施。

The uncleaned superheater, reheater should have oxygenated blowwash.

未经清洗的过热器、再热器应进行蒸汽加氧吹洗。

The reheater desuperheating water exerts great influence on the unit economy.

再热减温水对机组经济性的影响很大。

For manufacture wall panel, economizer, reheater, superheater and steam pipeline of boilers.

用于锅炉水冷壁、省煤器、再热器、过热器和蒸气管道的制造。

For manufacture water wall panel, economizer, reheater, superheater and pipeline of boilers.

用于锅炉水冷壁、省煤器、再热器、过热器和蒸气管道的制造。

The method of turbine regulation has to be considered in the design of steam boiler reheater.

中间过热器的设计与汽轮机的调节方法有关。

It also provides the basis for solving the bursting leakage by ultra high temperature of the secondary reheater due to the slagging on boiler water wall.

为解决锅炉水冷壁结焦所引发的二次再热器超温爆漏问题提供了依据。

A universal formula is raised to calculate flow of reheater when a unit of work substance is pushed out from extraction steam in reheating unit, and verified...

导出了在再热机组中，排挤单位非调节抽汽流经再热器流量份额的通用计算式，并进行了验证。

The superheater and reheater on-line metal temperature monitoring technique used a limited number of metal temperature measuring points situated outside of the.

过热器再热器壁温在线监测技术，可以通过安装少量的炉外壁温测点，实时计算整个管组各部位的金属壁温。

The packing method of radiographic films and identification of containers of the MSR(moisture seprarator reheater)for Lingao nuclear power station is introduced.

介绍广东深圳岭澳核电站汽水分离再热器射线底片的运输包装及底片盒的标识方法。

After a detail calculation and analysis, the reason that the flow distribution coefficient of a flow divider in the primary reheater was too small had been found.

在进行了详细的计算分析后，发现主要是由于低温再热器进口流量分配器流量分配系数太小所致。

This paper simply presents the commissioning of moisture separator reheater (MSR) system and its monitored control system (RTC_5) of Qinshan NPP 300mw turbine generator.

本文简要地介绍了秦山核电厂300 MW汽轮发电机组汽水分离再热器(MSR)系统及其监控(再热温度控制器——rtc_5)系统的调试、投运等。

A universal formula is raised to calculate flow of reheater when a unit of work substance is pushed out from extraction steam in reheating unit, and verified by examples.

导出了在再热机组中，排挤单位非调节抽汽流经再热器流量份额的通用计算式，并进行了验证。

It emphases discussing moisture structure applied in LP steam path and principle of moisture separator reheater, the other methods of moisture removing are also introduced.

重点讨论了低压通流中采用的去湿结构和汽水分离再热系统的原理以及其它去湿方法的应用。

The moisture separator reheater which used in nuclear power station was a complex structure, the NDT was according to British standards and French ALSTOM project standards.

核电站用汽水分离再热器结构复杂，无损检测按英国国家标准和法国ALSTOM公司工程标准进行。

Through tests, the wall temperature distribution of platen type reheater has been obtained, and the over-temperature of reheater tube being known from the analysis of test results.

通过试验得到屏式再热器的壁温分布，分析试验结果找出超温的再热器管。

The deviation is a important reason causing reheater tube failure of 300MW and 600MW boiler. It is experienced that steam temperature is higher at right 1/4 area of reheater system.

MW锅炉的偏差温度是引起再热器爆管的一个重要原因，在再热器系统表现为沿炉宽方向右1/4区域汽温较高。

The causes for local overtemperature of high temperature reheater of 600 MW boiler in Beilun Power Plant and that bypass retrofit could not realize the expected effect are analyzed;

分析了北仑发电厂600 M W 锅炉再热器局部超温及旁路改造未能达到预期效果的原因；

The superheater and reheater overheating occurred in early 300MW, 600MW boilers and their reasons are detailed and analyzed, and the improvement and optimization measure are put forward.

对早期的300MW、600MW锅炉存在的过热器、再热器超温问题及原因进行了论述和分析，提出了改进、优化措施。

Through improving the connection mode of platen reheater and decreasing the heating surface, the overheating of platen reheater was eliminated and the safe operation of unit was ensured.

经改进屏式再热器连接方式并减少受热面后，消除了屏式再热器超温，保证了机组安全运行。

Based on analysis of the cause of tube explosion, which frequently happens on the hot stage reheater of boilers No. 1and 2 in Hanchan power Plant, authors put forward improvement measures.

本文针对汉川电厂1、2号炉末级再热器爆管问题，分析了爆管原因，提出了改进措施。

In this paper, the reheater difference between nuclear power plant and coal-firing power plant was given, and the MSR system's craft and control for nuclear power plant was also discussed.

比较了核电机组与火电机组再热系统的不同特性，阐述了重水堆核电机组汽水分离再热器系统的流程和控制。

The paper describes the test results of improvement effects on a licensed 300mw set's boiler and its reheater for the purpose of diminishing reheater's mass flow and temperature deviations.

该文介绍引进型300 MW机组锅炉、再热器系统经改进，减少再热蒸汽流量偏差和温度偏差的实炉试验结果。

The practical experience shows that in the light of steam purging for supercritical once-through boiler, the superheater and reheater disturbance coefficients can reach 1.0 and 1.6 respectively.

利用减温水控制过热器和再热器出口温度以防止超过材料温限。实践证明，对超临界直流锅炉采用投粉稳压冲管过热器、再热器冲管系数可达1.0和1.6以上，效果良好。

The article describes the critical and hard parts and technology measures of stainless steel membrane panel's manufacture, which be used in high temperature Reheater of large capacity CFB boiler.

大型循环流化床锅炉高温再热器中所采用的不锈钢膜式壁管屏的制造工艺要点和难点，以及解决的工艺措施。